Thermolec Thermo-Air Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Radiateurs Thermolec Thermo-Air. Thermolec Thermo-Air Manuel d'utilisation Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Installation Instructions for THERMO-AIR and THERMO-ZONE units.
Please read instructions carefully before starting.
Mechanical Installation.
1- The air direction may be either vertical or horizontal, but when the unit is installed horizontally, the
cut-out cover must be on top.
2- Do not install elbows closer
than 12 inches to either the
inlet or outlet of the unit.
3- The electronic controller shuts down the heater when there is no air ow.
The minimum amount of air required (in cubic feet per minute) to operate the unit is given in the CFM
column of the table (30 CFM per kilowatt).
If CFM is lower than speci ed, the air ow sensor will limit the total capacity according to the air ow
available.
4- Attach the unit to a
suitable support.
The 6” model is small enough
to be located between
standard 16” spaced oor
joists.
Always allow a minimum
1/2” clearance above the heater.
LTD.
Top
Thermal cut-out
Cover
O.K.
O.K.
O.K.
12''
O.K.
12''
Control
Box
Heater
Wall
Control
Box
Heater
Mur
2'' x 10''
Joist
8''
16''
11 1/2''
1/2''
Clearance
Floor
April 2007. V2.0
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - 12''

Installation Instructions for THERMO-AIR and THERMO-ZONE units.Please read instructions carefully before starting.Mechanical Installation.1- The a

Page 2 - Fresh Air and Zone Heaters

5- Electrical Installation.Please conform to all local and national electrical codes for wiring. The heater should be supplied by a separate cable, of

Page 3 - ReheatPreheat

6- Special Instructions for each type of unit.THERMO-AIR (TER models in Fig. 1)When the unit is installed and connected, set the potentiometer on th

Page 4 - “S S” on the controller

THERMO-ZONE (ZON models in Fig. 1)When the unit is installed and connected, set the potentiometer on the controller to “R” (remote). Install th

Page 5 - ”S S” sur le contrôleur

THERMO-ZONE (Modèles ZON dans le tableau précédent)Quand l’appareil est installé et connecté, ajuster le potentiomètre situé sur le contrôleur à la

Page 6 - LOAD 1 LINE

6- Remarques particulières à chaque appareil.THERMO-AIR (Modèles TER dans le tableau précédent)Quand l’appareil est installé et connecté, ajuster l

Page 7

5- Installation électrique.Suivre les codes nationaux et locaux pour le raccordement électrique. Il est recommandé d’alimenter l’appareil par un câble

Page 8 - Avril 2007. V2.0

Instructions d’installation pour les appareils THERMO-AIR et THERMO-ZONE.Lire attentivement les instructions avant de faire l’installation.Installa

Modèles reliés Thermo-Zone

Commentaires sur ces manuels

Pas de commentaire